Innokin VTRMaximize

Innokin VTR

Average rating: 4.9 out of 95 reviews

Availability:Out of stock


Notify me when available

$69.99

Reduced price!

-$30.00

$99.99

Add to cart


Condition: new
all prices $USD

Customers who bought this product also bought:

This is the Genuine original Innokin iTaste VTR VV/VW MOD e cigarette vaporizer kit. It  is a variable voltage and variable wattage vaporizer.

 

1, Variable Voltage: Voltage can be adjusted from 3.0-6.0 volts in 0.1 volt increments.

2, Variable Wattage: Wattage can be adjusted from 3.0-15.0w in 0.5 watts increments.

3, Short Circuit Portection function available.

4, RMS: Root mean square

5, Reverse Battery Protection Circuit.

6, Resistive Load Detection(Ohms meter)

7, ON/OFF battery switch

8, LED Battery Power Display

9, Low Voltage Warning

10, Overtime Vaping Warning(10 second switch cutoff)

11, Battery safety protection(vent holes)

12, High compatibility 510 connector(510/eGo threaded) with help of cone adapter connector.

13, Remember last set voltage or wattage setting after switching batteries.

14, Built-in 3 digit display(Ohms meter, Volts/Watts, Atomizer voltage output)

15, Replaceable Battery: iTaste VTR supports 18650 batteries(unprotected)

16, Dimension: 22.2*54.4*106mm

17, Maximum Current Output: 5.0 Amperage


Please be kindly noted that:

 

The itaste VTR MOD is compatible with 510/eGo/eGo-T/eGo-C atomizers/clearomizers using the cone adapter connector.

It is empty without ejuice and 18650 battery, so you should buy them separately.


Including:

iTaste VTR body                                               X  1 pc
iClear30S cartomizer(1.8ohm coil unit)             X 1 pc
510 cone adapter connector                            X 1 pc

Manual                                                             X 1 pc


Useful Tips:


1, When the battery is installed, the LED light will blink from red to yellow to green and the digital display will show 88.8 The VTR will be in off mode.


2, Press the "Function Key" for 2 seconds to check Resistance of your attached atomizer or clearomizer.


3, To display the current voltage or wattage setting, press and hold the "Function Key" for one second and release.


4, Battery Level Indicator

 

   The battery capacity is displayed via green, yellow, and red LED lights;


      Green :  Fully Charged

      Yellow:  Half Discharged

       Red:  Charge Needed


5, High compatibility 510 connector


    Will fit iClear10, iClear16, and iClear30 clearomizer, as well as standard 510 accessories.


6, ON/OFF Battery Switch


   Quickly clicking the power button three times will enable the battery, Once enabled, holding down the button will activate the device.

  This safety feature prevents the atomizers from turning on while it is in your pocket or bag and prevent accidental changes to your settings.


7, Replaceable Batteries: The iTaste VTR supports 18650 batteries.


8,  10-Seconds Cutoff, Short Circuit Portection, Reverse Battery Protection Circuit, etc...


9, Battery Level Indicator:


  Red LED light: Battery voltage lower than 3.61v

    Yellow LED light: Battery voltage around 3.61-3.75v

    Green LED light: battery voltage highter than 3.75v

    Red LED will keep blinking for 8 seconds when battery capacity is lower than 3.3v and the iTaste VTR show Low and will turn off.

    Red LED light will stay lit for 5 seconds when a load short circuit is detected, then no vapor will be produced.